Extended Warranty Plan Overview

We have three different levels of extended warranty coverage: powertrain, powertrain + hydraulics, and platform. See the differences between the three options below.

Covered By All Plans

  1. We will pay for replacement of necessary fluids, oils, greases, lubricants and approved A/C gases that must be replaced in conjunction with a covered repair. THIS COVERAGE DOES NOT APPLY TO SHOP SUPPLIES.
  2. We will pay for reasonable, necessary and customary diagnostic charges incurred in conjunction with a covered repair, not to exceed the labor time listed in a nationally recognized parts and labor guide.
    1. Diagnostic time will not be paid when the needed repair is readily apparent to the normal senses of sight, touch, smell and/or sound.
    2. Diagnostic costs that will exceed $500 must be pre-approved by the Administrator.
  3. Related Damage Coverage: We will pay for the replacement of brake pads, belts and hoses that are damaged and require replacement as a direct result of a covered Mechanical Breakdown, providing more than 50% of life of the part, existed at the time of failure.

Powertrain Extended Warranty

The Powertrain group includes the following components which produce, transmit or control engine horsepower for propelling the machine:

  • Core engine (except hang-on attachments), Engine flywheel.
  • Engine lubrication system (except oil and oil filter)
  • Engine electronic control modules & sensors(e.g., electronic control module – ECM)
  • Turbo air induction & exhaust system (except muffler, hoses/tubes, exhaust stack & air filters).
  • Engine water pump and water temperature regulator.
  • Fuel injection components(Injectors are limited to factory defects under 2000 engine hours but not covered for failure due to normal wear).
  • Engine drive-line coupler, drive-line shafts, U-joints, transfer gears & differential.
  • Transmission, transmission oil pumps, valves, controls & sensors.
  • Final drives, mechanical drive axles (Factory installed) and non-powered axles (Except Auto-steer & suspension systems). Hydraulic components for rear wheel assist are covered under “HYDRAULICS” coverage.
  • Hydro propel pumps, motors, controls, sensors & metal lines (Pumps and motors for Hydro-powered threshing cylinders on combines are not covered–they are considered part of Hydraulic System)
  • Powertrain coverage includes the Engine power supply to the mechanical thrashing cylinder/rotor. Powertrain coverage stops at the end of the output shaft of the final gearbox/hydraulic motor that drives the trashing cylinder/rotor.
  • Combine Reverser unit (limited to the unit and its internal components only)
  • Power take off (PTO) components, contained within the axle casting.
  • Electronic clutch on commercial mowers.

Powertrain + Hydraulics Extended Warranty

The Powertrain + Hydraulics extended warranty plan covers all of the Powertrain group above, plus hydraulic systems parts and components associated with steering, rear wheel assist, and implement control: It does not include Auto-Steer, Suspension or Self Leveling components. The Powertrain + Hydraulics extended warranty plan covers the following:

  • All of the “Powertrain” covereage.
  • Electronic clutch on commercial mowers.
  • Hydraulic pumps, oil coolers, motors, controls & sensors.
  • Hydraulic valves, cylinders, accumulators, metal lines, filter bases.

Platform Extended Warranty

The Platform group includes all components in the Powertrain group + Hydraulic Systems group plus additional mechanical, electrical and structural components. The additional mechanical, electrical, and structural components covered are:
  • All of the “Powertrain” coverage.
  • All of the “Powertrain + Hydraulics” coverage.
  • Engine starting aid, starter, alternator, air compressor & engine block heater
  • Air conditioning compressor, evaporator, condenser, and connecting lines.
  • Radiator, fan drive, coolant reservoir & coolant hoses/lines
  • Air inlet/exhaust hoses/tubes (except muffler and exhaust stack)
  • Fuel tanks & tank-attached fuel lines
  • Auto steer (factory installed)
  • Self-leveling systems (combines)
  • Front-axle suspension (factory installed)
  • Service brake system components (except friction pads/shoes and related wear parts)
  • Cab frame enclosure, mounting, platform & suspension
  • ROPS, FOPS and Back-up alarm

Plan Comparison for New vs Old